Mediaclient

Mediaclient

DVB-S/S2/S2X Tuning

/opt/bin/mediaclient -m DVBS -f 12400000 -M 8PSK -S 27500000 -E 2/3 -V V

-m DVBS or DVBS2

-f Frequency in KHz

-M modulation 8PSK or QPSK

-S Symbol Rate

-E FEC

-V Voltage (V or H)

Additional for Multistream (just skip it if not needed):

--plsmode=[GOLD, COMMON, ROOT]

--plscode=[plscode]

--isi=[stream id]

please note that those parameters very likely don't match the setup of your dish and you might not get a [LOCKED]. This is only an example what the commandline string looks like. Adjust it to parameters which are suitable for your setup. Eg. get the DVB-S/S2 parameters from https://lyngsat.com

Example for Multistream:

Eutelsat 5 West B at 5.0°W

/opt/bin/mediaclient -m DVBS2 -f 12536000 -M 8PSK -S 35300000 -E 2/3 -V H --plsmode=GOLD --plscode=131070 --isi=9

DVB-C Tuning

/opt/bin/mediaclient -m DVBC -f 450000000 -S 6900000 -M Q256

-f Frequency in Hz

-S Symbol Rate

-M Modulation Q256 or Q128 or Q64

DVB-T/T2 Tuning

/opt/bin/mediaclient -m DVBT -f 450000000 -b 8

DVBT or DVBT2

-f Frequency in Hz

-b bandwidth in Mhz

If the device supports DVB-T2 the driver will also lock on DVB-T2 transponder (regardless if DVBT only is set)

Reading Signal statistics

/opt/bin/mediaclient --readsignal=0 --band=universal -d /dev/dvb/adapter0/frontend0

--readsignal=N N.. 0=infinite; N.. times

-d device name

--band=universal .. for DVB-S/S2 Universal LNB (to recalculate the current frequency), for C-Band use cband (for DVB-T or DVB-C skip this command

Scanning transponder

/opt/bin/mediaclient --tsscan /dev/dvb/adapter0/dvr0